Tuesday, May 29, 2012

everytime i watch this my mind explodes. i am so lucky to have jeremy on my side. he is one of the most down to earth people i have ever met, and comes up with some of the most unique ideas conceivable.

Motor Mike

This weekend my dude Motor Mike came up from vegas to hang out before he hits the road again for the air force. Mike is one hell of a nice guy and a good shot with a camera. check out his blog HERE 

 Mike wanted to help on the BF bike so i got him into some casting clean up. 

 Turns out he is pretty handy with a file.

 He also installed these jeweled turn signals. 

 here i am creating the air filter opening in the right side fairing panel 

beginnings of a clamp.

making chips.



asking for metal in my eye.

thanks for the help mike good luck on the adventure. 

Wednesday, May 23, 2012

as the cro flys

caleb builds cool stuff..... no questions asked. 

Monday, May 21, 2012

i have been jamming like a mad man at the shop lately. here are a bunch of photos of what i have been working on. i hope you can dig it!

here are some pegs that i had cast for this project. fully adjustable 

built in levers shaped out of some 3/8 plate and a lot of file work. 
 finally wrapped up the air cooled down pipe. 

 header pipes are complete and metal finished. 

 dash board shaping block.

 dash board roughed out. 

 de bumping the primary since it doesn't have a compensator anymore.

shaving off a couple inches on the primary.

here is the cover roughed in.

center stand is pretty well finished i just need to build the spring mech now. 

psi tested the oil tank, and brazed the jic fittings in place.

upper oil tank mount is all done, going to have to re plate the battery box. 

machined the clutch spring opening in the cover. 

working on mounting the split tanks. 

 did some shaping on the brake pedal. i actually extended the lever as well. 

 machined a little weld in detail trim ring for the clutch springs. 

 moved the waste gate actuator mount. 

 and cleaned the unit up a bit. 

i didn't like the lever on the pet cock so this little knob was whipped up on the late and mill.

how do you bolt down a noodle?

 turbo support.

 the turbo puts off tons of heat and i don't want it to melt the fairing so i am building the lower half in aluminum. 

here it is mounted up. there will actually be an air filter box built into this section of the fairing. 

Monday, May 14, 2012

Born Free Builders video.

Jeremy Miller and i have been working on this little born free promo video for the last couple weeks.  Jeremy did a phenomenal job on it, i can't believe how well it turned out. thank you jeremy. check out j-mills ent.  here.

Sunday, May 13, 2012

check out my friends band Drag Me Under they just put out this video and i just so happens to have some pangea speed pride in it. thanks jeromy and maurice.